Prepare The Receiver Collar; Charge The Receiver Collar - Petsafe PDT20-11939 Guia De Funcionamiento

+2 Boost
A press of the +2 Boost button sends a signal to the collar to issue a correction
that is 2 levels higher than the currently selected level. For example, if the
correction level is set at Level 2, a touch of the +2 Boost control will correct at
Level 4. The system will not correct higher than level 10.
________________________________________________________________
Remote Transmitter Belt
Clip
To remove:
1. Press down and hold the Release on
the Belt Clip.
2. Press upward on the Release and
slide the Belt Clip out
of the insert.
To replace:
1. Slide the Belt Clip into the insert
until it clicks.
____________________________________
Step

Prepare the Receiver Collar

2
Charge the
Receiver Collar
1. Lift the rubber cover
protecting the Receiver
Collar Charging Jack.
2. Connect the charger
connector to the Receiver
Collar Charging Jack.
350 metre Little Dog
Receiver Collar
Charger
connector
placed in
Receiver
Collar
Charging
Jack
www.petsafe.net
Belt Clip
Lanyard Clip
9