Publicidad
Figure 19/ Figura 19
Figure 20/ Figura 20
Step / Étape / Paso
Figure 21/ Figura 21
Tipping Hazard: For upright storage, leave the A-Frame open wide enough to remain stable, or secure to the
wall to prevent tipping. In households with small children the table should be stored flat on the floor, not upright.
MAINTENANCE
• Unplug the inversion table before performing maintenance.
• To clean the Table Bed, wipe down with a damp cloth.
• Do not use abrasive cleaners.
SAFETY LOCK and KEY
• The Safety Lock allows the table to be deactivated without the need to unplug
the power supply.
• Insert the Safety Key and turn clockwise to disable the Safety Lock and engage
the motor. The Safety Key will remain in place when the table is in-use (Figure 19).
• Upon completion of your inversion session, turn the Safety Key counterclockwise,
remove from the Motor Housing and store in a secure place for future use.
STORING THE INVERSION TABLE
• Loosen the De-Rattler Knob.
• Pull the height-selector locking pin, slide the Main Shaft in all the way, and engage
the pin in the storage setting.
• By pressing the Rotation Adjustment Button, rotate the Table Bed to its fully
inverted position until it reaches the Crossbar (Figure 20).
• Unplug the inversion table before storing.
• Pull up on the Spreader Arms to fold the A-frame (Figure 21).
CAUTION: Proceed carefully. This product is heavy. Folding the A-Frame may
pinch fingers if not done cautiously.
• Be sure to leave the A-Frame partially open, as to prevent tipping.
• Ensure that the electrical cord has been properly stored while not in use.
WARNING
!
7
Publicidad
