DeLonghi DOLCE VITA ELETTRICO Manual De Instrucciones Para El Uso página 20

ANTI-FREEZE
In "Anti-Freeze" mode, the temperature set point
The appliance starts heating automatically when
GB
the room temperature drops below 7 °C.
All "Pilot Wire" commands are disabled.
CHRONO
In this mode, you can select one of the three pre-
set chrono-thermostat programs or the custom
program. The latter lets you set a daily and weekly
program with two temperature levels ("Comfort"
All "Pilot Wire" commands are disabled.
ENERGY SAVING
This mode reduces the appliance's energy con-
sumption when the room is left unoccupied. Tem-
All "Pilot Wire" commands are disabled.
When the icon
ing element is on.
4.2.1 PILOT WIRE
To activate the "Pilot Wire" mode:
Press the "Mode" selection key until the icon
appears on the LCD.
Users can only set the "Comfort" temperature
on the appliance.
Select the desired temperature set point by
using the "+" or "-" keys.
porting this type of technology. In this case, correct trans-
ing the following diagram according to the mode set:
Mode Comfort (Comfort
Signal to be
transmitted
Voltage
between
0 volt 230 volt
Pilot Wire and
neutral wires
is displayed on the LCD, the heat-
Comfort
Anti-Freeze Standby
-1 °C
-3,5 °C)
230 volt For
115 volt 115 volt
an interval
Negative Positive
of 3 s
The icon showing the mode selected on the control unit
gether with the
If the Pilot Wire programmer is not connected, "Comfort" op-
erating mode is selected automatically.
4.2.2 COMFORT
The "Comfort" temperature set point is the temperature
desired by the user.
4.2.3 NIGHT/ECO
higher than "Comfort" temperature set point. If the "Com-
the latter will be automatically adjusted accordingly.
The use of this operating mode is recommended in night-
time hours and in case no people is in the room for more
than 2 hours.
4.2.4 ANTI-FREEZE
-
-
7 °C. The appliance starts heating when room temperature
goes under 7 °C and with low energy consumption it pre-
vents the room temperature to reach the freezing point.
Comfort
-2 °C
This operating mode is recommended when no people is in
230 volt For
an interval
the room for more than 1 day.
of 7 s
18
icon.
Press the "Mode" selection key until the icon
appears on the LCD.
Select the desired temperature set point by
using the "+" or "-" keys.
The temperature can be choosen in the inter-
val between 7 °C and 32 °C.
Press the "Mode" selection key until the icon
appears on the LCD.
Select the desired temperature set point by
using the "+" or "-" keys.
Press the "Mode" selection key until the icon
appears on the LCD.
-