Tabla de contenido
Publicidad
pletely from the household mains in accordance with the wiring rules.
current protection device).
GB
Permanently connected appliances must be connected using a connector block placed within a proper junction box.
When installing the appliance in damp rooms (kitchen, bathroom), the point of connection with the household mains
Fig. 10
Appliance cable
The Pilote Wire mode is not available on this device. The corresponding (black) wire must therefore be
insulated.
The Pilot Wire terminal must never be connected to the ground system.
Make sure the power cable cannot in any way come into contact with the surface of the appliance (Fig. 9).
3.3 HYDRAULIC CONNECTION
You are recommended to have the appliance ins-
The appliance must be connected to professional
standards and in respect of national regulations on
hydraulic installations.
The maximum water temperature should be 75 °C.
The maximum working pressure should be of 4.5
bar.
4. REGULATION AND OPERATION
This appliance is designed to heat
domestic rooms or similar and to dry
towels.
Some parts of this product can be-
come very hot and cause burns.
Particular attention has to be given
where children and vulnerable peo-
ple are present.
PHASE = BROWN
NEUTRAL = GREY/BLUE
PILOT WIRE = BLACK
PHASE
NEUTRAL
DON'T CONNECT
least 50 cm from the appliance. Do not vaporise any
type of substance on the surface of the appliance.
Never touch the appliance with wet or damp hands
or feet.
Do not wet the electronic control unit with water or
from the mains power supply and allow to dry com-
pletely.
When the appliance is installed at high altitude,
the air will be hotter than the set temperature.
To turn off the appliance completely, switch off
the main switch by moving it in the "O" position.
This is recommended whenever the appliance is
not used for long periods.
14
Household mains
-
-
Publicidad
Tabla de contenido
