Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NOTES FOR CONNECTING TO A TV:
•
Connect the DVD player with the AV cable into the TV AV in.
•
Set the TV's TV/VIDEO button or switch to the VIDEO setting.
•
When connecting the DVD, refer to the owner's manual of the TV, as well as this manual.
•
When connecting the DVD to the TV, make sure the power is off and both units are unplugged before
making any connections.
•
If your TV only has one audio input, the use of a "Y" connector may be necessary. Visit your local
electronics supply store.
•
Connect the DVD player to your TV directly. If you connect the DVD player through a VCR, the
playback picture will be distorted because DVD video discs are copy protected.
CONNECTING ThE DVD TO A hOME ThEATER SYSTEM
1. Front Left Speaker
2. Television
3. Center Speaker- can be located
on top or below the Television.
4. Sub-woofer- can be located on
anywhere in the room.
5. Front Right Speaker
6. Viewing/Listening Position-
The best listening position is obtained
by positioning the chair, sofa, etc. in the
middle of all the speakers.
7. Rear Left Speaker
8. Rear Right Speaker
9. AV Amplifier w/Dolby Digital Decoder/DTS Decoder
Place the subwoofer, front, rear and center speakers in locations as shown / described here.
After correctly positioning the speakers, perform the Tone Test on the AV Amplifer and adjust
the volume controls until the desired sound is achieved. For best results, sit in the viewing
position and have someone adjust the volumes for you; this will enable you to set the optimal
levels.
NOTE: the rear speakers can also be located on the side wall facing the viewing position and
each other. Make sure the viewing position is located between the 2 speakers in this case.
Experiment to find optimal position.
C00PDE Zoram Eng.indd 6
CONNECTION
GB - 6
From
Digital Out
Coaxial Cable
AV Cable
To Digital
Audio Input
2009/8/12 2:26:48 PM
Publicidad
Tabla de contenido
