Control Elements - LD Systems LAX6 Manual De Usuario

CONTROL ELEMENTS:

1 MONO CHANNELS (MIC/LINE)
The mono channels offer balanced XLR connectors for low-impedance
microphones and other low-level equipment. In addition, there are 6.3 mm
TRS jack input connectors for microphones and line level equipment (e.g.,
synthesizers, drum computers, effects processors, etc.).
Note: The MIC and LINE inputs cannot be used simultaneously on the same
channel. +48V phantom power. Both XLR inputs on the mono channels
provide +48V phantom power for condenser microphones.
INPUT GAIN ADJUSTMENT
2
The input gain (TRIM) control has two different scales: one for microphones
and one for line level devices. The outer ring (0 ~ 44 dB) refers to micro-
phones, the inner one (+15 ~ -30 dB) to line level devices. Always adjust
the gain control so that the peak LED above the channel level knob lights up
only occasionally. If the LED is on constantly, this can lead to distortion.
STEREO CHANNELSThe stereo channels are configured as stereo pairs
3
with 6.3 mm jack input connectors. Mono signal sources should be
connected to the left jack input connector.
BAND EQUALIZER
All input channels of the LAX6/LAX6D are equipped with 3-band equalizers.
HI
4
This knob is used to control the high frequencies. You can use it to add more
brilliance and presence to the corresponding signal or attenuate undesirably
loud high frequencies (boost/cut range -15 dB to +15 dB, centre frequency
12 kHz).
5 MID
This knob is used to control the midrange frequencies. These are the most
important frequencies for musical instruments and the human voice (boost/
cut range -12 dB to +12 dB, centre frequency 2.5 kHz).
LOW
6
This knob is used to control the low frequencies. You can use it, for example,
to boost a bass drum, bass guitar or male voice (boost/cut range -15 dB to
+15 dB, centre frequency 80 Hz).
8
MIC 1
1
BAL OR
UNBAL
LINE IN 1
TRIM
2
+15dB -25dB LINE
0dB 40dB MIC
LINE IN 3/4 LINE IN 5/6
LEFT(MONO) LEFT (MONO)
3
RIGHT RIGHT
0
EQ
HI
4
12kHz
-15 +15
0
5 MID
2.5kHz
-12 +12
0
LOW
6
80Hz
-15 +15
0
AUX
DFX
POST
7
(PRE)
-
+15
PAN
8
LR
9
0
PEAK
10
-
+15
1