Tools Required; Mounting Steps - Hella Comet FF 100 Instrucciones De Montaje

10
Accessories, see Fig. page 6
(not included with kit)
Attachment dimensions:
For upright/pendant mounting,
above/below bumper. Lamps
should neither vibrate nor extend
higher than the bonnet and must
be fitted symmetrically.

Tools required:

Mounting steps:

Please Note:
For a satisfactory paint finish,
please have the headlamp
housing (material PC) painted in a
specialist paint shop.
1. Two-point mount
2. Wiring harness with relay
C D
• Ruler
• Combination pliers
• 10 mm open-end or box wrench
• Hexagon socket screw key (SW 5)
1. Determine mounting position
and mark mounting points accor-
ding to attachment dimensions
given above.
2. Drill pilot hole with 3 mm dia.
bit and then bore out to 6.5 mm.
Protect drilled metal parts with rust
protection paint.
3. Protective grille
The table shows the possibilities
permitted in the various countries:
C
• 4 and 5 mm Allen Keys
• Drill with 3/ 6.5/ 12 mm dia. bits
• Insulating tape
3. Remove lamp set, press rubber
grommet in from inside and install
stabilization ring (Fig.1; 2).
4. Preinstall bracket (Fig. 3) and
assemble with housing depending
on desired position (Fig. 4).
Tighten bolts hand-tight.
(also see
"One more tip")