Package Content; Installation Of The Accessory - WEG CFW500 Guía De Instalación, Configuración Y Operación

RS232 Communication Plug-in Module

3 PACKAGE CONTENT

When receiving the product, check if this package
contains:
Accessory in antistatic package.
„
Installation, configuration and operation guide.
„
NOTE!
Serial cable not included.

4 INSTALLATION OF THE ACCESSORY

The accessory is easily installed or replaced. For the
proper installation of the accessory, follow the steps
below:
Step 1: With the inverter deenergized, remove its front
cover as shown in
Step 2: Remove the accessor y (plug-in module
connected), if present, as shown in
Step 3: Position and press the accessory to be installed
as shown in figure A.1 (b)
cover of the inverter.
Step 4: Energize the inverter and check if parameter
P0027 shows the value 7 (P0027 = 7). In case this
information is not true, check if conected module the
CFW500-CRS232 and repeat steps 1-4.
6 | CFW500
figure A.1 (a).
and then connect the front
figure A.1 (a).