Alcad 912 Serie Manual De Usuario página 23

3. BASIC CONCEPTS
3.1. Charging and Changing Batteries
Before turning on the remote for the fi rst time, make sure that the rechargeable batteries are positioned
correctly. When you have done this, connect the programmer to the mains supply and leave it connected
until a complete charging cycle has been completed.
During the charging process, the icon of a battery being charged will appear on the screen and the LED
located next to the power supply connector will remain lit up. When the batteries are completely charged,
the LED will blink and the icon of a fully charged battery will appear on the screen.
The rechargeable batteries supplied with the programmer are charged using the DC charger which is
also supplied with the PS-011.
Charging led
The PS-011 programmer will work when connected to the mains supply whether the batteries are installed
or not. Note also that if the batteries of the programmer run down and you do not have access to a 230V
plug, you can use AA alkaline batteries instead. You must bear in mind, however, that the autonomy of
this type of battery may be considerably reduced.
PS-011 MANUAL
PS-011 MANUAL
Power supply
connector
PAG. 23
ENG