Skin Sensitivity Test; Treating With Me - Elos me Guia Del Usuario

skin sensitivity test

If you are using the system for the first time or in new body area, choose a
small area close to the area you intend to treat, for the purpose of performing
a skin sensitivity test. Use the LOW
below but make sure to emit only 2-3 pulses. After the skin test, wait 30
minutes and check your skin for any reaction. If after 30 minutes the skin
appears normal, then you are ready to perform a full treatment.
treating with
1
3
Body:
Step 1. For your convenience, you can use the
or shaver accessories to remove hair. If you do so, there is
no need for preparations before the treatment, only make
sure the hair is no longer than 0.5 cm. Remove the protective
cap, and insert the epilator or shaver cartridge instead.
If you do not use the designated
epilator accessories, shave any hairs with a razor or electric
shaver. Make sure that the protective cap (provided) is
inserted. The system will not work if the protective cap or
epilator/shaver accessory is not in place.
Step 2. Clean your skin and dry it with a towel.
Step 3. Press the
appropriate level (Low, Medium or High). Press the
button again to move from Low to Medium and again to
move from Medium to High. In order to return to the Low
setting you must press the
It is recommended to start on Low and move to a higher
level if you feel comfortable.
level. Follow the treatment instructions
system shaver or
button on the base to select the
button again.
epilator
EN 12