Assembly Components; Handle Assembly - Alpina B 26 J Manual De Instrucciones

1. Cutting line head: nylon
line cutting means
2. 3-point blade: metallic
disc cutting means
3. Saw blade (if permitted):
circular metal cutting means
with peripheral cutting teeth
E. Cutting means guard: it is a safety
device which prevents objects drawn
up by the cutting means from being
hurled away from the machine.
Front hand grip: semi-circular shaped,
F.
it is used to handle the machine and
is equipped with a leg guard.
G. Rear hand grip: used to handle the
machine and equipped with the main
on/of/acceleration control buttons.
H. Leg guard: a safety guard that
prevents accidental contact with
the cutting means during use.
Handle bar: "bull horn" shaped handle bar
I.
placed crosswise and asymmetrically to
the shaft; used to handle the machine and
equipped with the main on/of/acceleration
control buttons on the right hand side.
Connection point (of the harness): where
J.
the harness is connected to the machine.
K. Harness: device made up of a
fabric belt which, placed over the
shoulders, help to support the weight
of the machine during work:
1. single belt
2. double belt
3. with back-pack power unit
L. Blade protection (for machine
transport and handling): protects against
accidental contact with the cutting
means that can cause serious injuries.
4. ASSEMBLY
IMPORTANT The safety regulations to
follow during machine use are described
in Chapter 2. Strictly comply with these
instructions to avoid serious risks or hazards.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the
assembly should be done on a lat and stable
surface, with enough space for machine
handling and its packaging, always making
use of suitable equipment. Do not use the
machine until all the instructions in the
"ASSEMBLY" section have been carried out.

4.1 ASSEMBLY COMPONENTS

The packaging includes assembly components.
4.1.1 Unpacking
1. Cautiously open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the brush cutter from the box.
5. Dispose of the box and packaging in
compliance with local regulations.

4.2 HANDLE ASSEMBLY

4.2.1 Assembly of front handle
1. Position the cap (Fig. 3.A) inserting
the pin (ig.3.A.1) in one of the
holes on the drive tube.
2. Assemble front handle itted with leg guard
barrier (Fig. 3.B) using the screws (Fig.
3.C), taking care to maintain in position the
two antivibration half bearings (ig.3.D)
3. Fully tighten the screws (Fig. 3.C).
4.2.2 Assembly of handle bar - Type I
1. Loosen the central knob (Fig. 4.A)
and remove the capFig. 4.B).
2. Insert the handle bar (Fig. 4.C), making
sure that the controls are on the right.
3. Set the handle bar in the most comfortable
working position and lock it using the
cap (Fig. 4.B) and knob (Fig. 4.A).
4. Fit the casing of the controls (Fig. 4.D)
to the cable tie(Fig. 4.E).
NOTE By loosening the knob (Fig.
4.A), you can turn the handlebar
to reduce its size for storage.
EN - 6