E.
SERVICE.
High voltages are present in a strobe light system. Wait at least five
(5) minutes, after shutting off power, before servicing the unit.
Failure to do so may result in property damage, serious injury, or
death to you and others.
Servicing should be performed by a qualified Federal Signal service center. If the
power supply is not working properly, disconnect power and ground to the unit. Next,
disconnect the electrical connections to the strobe tubes. Remove the power supply from
the vehicle. Send the unit to the nearest authorized service center or to the Federal
Signal service department.
Communication and shipments should be addressed to:
Service Department
Federal Signal Corporation
2645 Federal Signal Drive
University Park, IL 60466
1-800-433-9132
(In Illinois) 708-534-3400
The fuse MUST be replaced with an exact replacement only.
After servicing is complete, perform a test to ensure the power supply is operating
properly.
F.
KIT CONTENTS LIST.
Qty.
Description
1
Power Supply
1
Fuse Holder with 8.0 ampere fuse
4
Self-tapping screws
4
Washers
WARNING
WARNING
-5-