Xm410 Input And Output Connections; Channel 1-6 Mic And Line Inputs; External Input Jacks (Aux In/Tape In) - Samson XM410 Manual Del Usuario

1
2
CHANNEL 1–6 MIC and LINE INPUTS
The XM410's six input channels each have a LINE level, Hi-Z (High Impedance) input and a MIC level, Low-Z
(Low impedance) input. By using the PAD switches, you can connect a variety of signal sources from micro-
phones to line level devices such as synthesizers, drum machines and direct boxes. Both LINE and MIC inputs
are balanced, with MIC inputs compatible with microphones of output impedance 50-600 Ohms and LINE
inputs compatible with line level devices of 600 Ohms.
NOTE: It is not possible to simultaneously use both the LINE and MIC inputs on the same channel. For each
channel, use only one of the inputs as appropriate for the input source.
LINE - Line Level Input
1
Use these inputs to connect high impedance microphones, synthesizers and drum machines. The LINE
inputs have a nominal operating level of -40dBV through - 10dBV.
TRS phone jacks Connector pin-out - Sleeve: Ground, Tip: Hot (+), Ring: Cold (-)
2
MIC - Microphone Input
Use these inputs to connect Low Impedance microphones and low level signals from direct boxes. The
MIC inputs have a nominal operating level of –50dBV through -20dBV. The MIC inputs also feature +48V
phantom power, allowing you to use condenser microphones. The Phantom Power is switched on/off
simultaneously for channels 1 through 6.
XLR Connector pin-out - Pin 1: Ground, Pin 2: Hot (+), Pin 3: Cold (-)
3
AUX 2 SEND - Effects Output
The AUX 2 SEND output is used to interface an external signal processor like a delay or reverb. The sig-
nal present at the AUX 2 SEND output is sent from the EFFECTS bus, which is fed from the EFX send on
the input channels and the EFFECTS LEVEL send in the Master section.
4
EFX FOOTSWITCH - Footswitch Jack
With a foot switch connected to this jack, you can turn on and off the on-board digital effects by simply pressing
the switch with your foot.

EXTERNAL INPUT JACKS (AUX IN/TAPE IN)

These are input jacks that allow the signal from an external device to be added to the MAIN output.
5
AUX IN - Auxiliary Input
Used to connect monaural output devices such as external effects processors.
6
TAPE IN - Tape Input
Used to connect a stereo output device such as cassette recorder or CD player.

XM410 Input and Output Connections

3
4
9
6 7
8
5
9