Samson Synth Seven Manual Del Usuario página 14

Frequency Select Menu
From the main performance page, press the MENU/SELECT Button to enter the Main Menu.
With FREQUENCY SETUP highlighted, press the MENU/SELECT button to enter the FREQUENCY SETUP sub-
menu.
Setting the Operating Frequency
Rotate the cursor to select the Frequency parameter.
Press the MENU/SELECT button to adjust the setting.
Rotate the MENU/SELECT knob to adjust the performance frequency.
Press the MENU/SELECT button to confirm and store the setting or press the POWER button to cancel the
selection and move back to the FREQUENCY SETUP sub-menu.
Frequency Select
518.000
Scan Spectrum
IR Set
Back
Scan the frequency band for a clean channel
Rotate the cursor to select the SCAN SPECTRUM parameter.
Press the MENU/SELECT button to activate the scan function.
Frequency Select
518.000
MHz
Scan Spectrum
IR Set
Back
Set the transmitter group and channel
Rotate the cursor to select the IR SCAN parameter.
Press the MENU/SELECT button to active the IR SET function. While the IR SET is in progress, position the
transmitter about 6-12" (15-30 cm) from the front of the UR7 receiver with the transmitter's IR window facing
the IR transmitter on the front panel of the receiver.
14
Frequency Select
518.000
MHz
Scan Spectrum
IR Set
Back
MHz
IR Set IR Set IR Set
Frequency Select
546.850
MHz
Scan Spectrum
IR Set
Back
Scan Spectrum
531.350
CH F05
MHz
IR Set IR Set IR Set
Frequency Select
531.350
MHz
Scan Spectrum
IR Set
Back
IR Set IR Set IR Set