Publicidad
Idiomas disponibles
Idiomas disponibles
Side Burner
•
Loosen side burner in side shelf by unscrewing and removing the two front screws holding the burner in
place. See A. Note: Do not loosen electrode screw.
•
Side burner ground line has two wires running into one connector tip. Runlonger wire through vent hole
above ignition module in side panel into right cabinet. Securely attach tip of long wire to connector pin on
regulator valve. See B.
•
Remove the 2 pre-installed screws from the valve control stem and set them aside. See C.
•
Insert valve control stem through hole in fascia. Attach bezel to fascia and valve face with previously
removed 2 screws. Attach bezel with black mark facing up. See D.
•
Place side burner tube over the valve orifice, making sure the orifice is inside the burner tube. Reattach
side burner to side shelf with the 2 previously removed screws. See E.
•
Run side burner ignition wire shown E from burner through side panel vent hole and into main cabinet.
Connect wire in later step.
•
Pushcontrol knob onto side burner valve control stem, and place cooking grate onto burner. See F.
A
o
D
\
40 "146.23686310
Publicidad
