Shindaiwa B450 Manual Del Propietario - Operador página 9

Assembly and Adjustments
Throttle Cable (Continued)
Connecting Throttle Cable Ends
B45008
Figure 9
Throttle Control Adjustment
B45012
Stop Switch Termi-
nals
Figure 11
4. Connect the powerhead throttle cable
with the throttle cable from the handle-
bar. See Figure 9.
IMPORTANT!
Make sure the metal end of the
powerhead throttle cable jacket fits in the
grooved end of the cable connector
Throttle Cable
Sleeve
B45009
Throttle Cable
Sleeve
Cable Ties
Cable Connector
5. Center the throttle cable sleeve over
the connected cable ends and place the
assembly in the throttle cable connector.
See Figures 9, 10.
6. Close the throttle cable connector using
hand pressure. See Figure 10.
Installing the
Connector
B45010
Throttle Cable
Connector
Figure 10
Hip Protector
Throttle Cable
Handlebar
7. Secure each end of the throttle connector
with a cable tie. See Figure 11.
8. Install the hip protector on the outer
tube. See inset of Figure 11.
Throttle Cable
Sleeve
B45011
Handlebar
Bracket
Handlebar Bracket Cap Screw
9