Control Panel - Vicks Germ-Free V790 Instrucciones De Funcionamiento

WEEKLY CLEANING AND MAINTENANCE ADVISORY
At least weekly cleaning is recommended, when the unit has been in use. Regular
cleaning prevents mineral scale buildup in the hot water reservoir. It also helps prevent
buildup of bacteria, molds or other microorganisms in the tank or system. This ensures
that your humidifier will operate at maximum efficiency. (See page 6 for full cleaning
instructions.)
HOW YOUR VICKS
WARM MIST
HUMIDIFIER WORKS
The model V790 humidifier uses
a two-step approach to eliminate
potentially harmful microorganisms
from the water before they are
spread with the mist into the air.
The first step uses a UV bulb, located
inside the base of the humidifier,
that shines on the water through a
special glass tube as it passes from
the cold water reservoirs to the hot
water reservoir. The second step is
the boiling action that takes place in
the hot water reservoir just before the mist is distributed to the air in the room.

CONTROL PANEL

POWER SWITCH
ON POSITION -
is pushed to the ON setting and the unit is
plugged in, the power is on. The blue "POWER"
indicator light will be illuminated.
OFF POSITION
is pushed to the "OFF" position, the "POWER"
indicator light will not be illuminated, indicating
that the power is "OFF". This should be used (in
addition to unplugging unit) before moving,
performing maintenance, etc.
REPLACE UV BULB
BULB WHEN LIT" signal light is continuous
illuminated during normal use (an occasional
faint glow may occur when switching power on or
other times, but this is normal), the bulb must be
replaced with the same special 3.5W bulb. See
the enclosed order form. The UV bulb will operate
at maximum output for approximately 2,000 hours.
The UV bulb may operate
When the push button switch
- When the push button switch
-
If the "REPLACE UV
V790 PHOTO
99.9% Germ Free Mist