Vicks Germ-Free V790 Instrucciones De Funcionamiento página 5

longer than 2,000 hours but at a reduced output. To keep your humidifier operating
at maximum efficiency it is recommended that the UV bulb be replaced after
2,000 hours of use.
REFILL INDICATOR - When illuminated, the water tanks need refilling. See the
section "Filling the Water Tanks". If still illuminated a few minutes after full tank
is placed on base, reposition water tanks. (Unit will operate with only one water
tank.) Each time you fill tanks, rinse tanks, hot water reservoir and cold water
reservoirs. Clean them according to CLEANING INSTRUCTIONS if minerals or
film are present.
RELATIVE HUMIDITY CONTROL - This controls the humidity level. If moderate
humidity is desired, the control should be turned counterclockwise toward "
and if higher humidity is desired, clockwise toward "
unpack your humidifier, you may find it has droplets of water on some surfaces.
This is normal as every unit is tested prior to shipping. Carefully unpack humidifier
and remove all packing material.
OPERATING INSTRUCTIONS
1. Place the base of the unit on a firm, flat, level and water resistant surface.
2. Fill the water tanks according to the instructions below and place on
humidifier base.
3. Plug the power cord firmly and completely into the wall outlet.
4. Push the power switch to the ON position (Lights may flicker momentarily).
Then turn the relative humidity knob clockwise until you hear a faint click. It will
be normal for the humidifier to take a few minutes to warm up and begin to mist.
5. When the water tanks are empty, (after approximately 24 hours running time),
the "REFILL WHEN LIT" lamp will go on, and the unit will stop heating. Refer
to the "FILLING THE WATER TANKS" section.
6. Whenever the water falls below the level of the float switch during operation,
the heating element will shut off and stop heating, and the REFILL indicator
will light.
7. The unit will operate as long as there is water in either tank and unit will
operate with either one or both tanks.
FILLING THE WATER TANKS
1. Before filling the water tanks, push the POWER switch to the "OFF" position
and unplug unit. Refer to CLEANING INSTRUCTIONS.
2. Remove water tanks from base, turn each tank upside down and remove tank
cap by turning counterclockwise. Fill tank with clean cold tap water. Replace
the tank cap by turning clockwise. Tighten firmly.
3. Carefully pick up tank, since it will be heavy when full, and slippery if wet.
4. Place water tanks on base. Make sure tanks are properly placed, otherwise,
the humidifier will not work correctly.
USING THE MEDICINE CUP
In order to add Vicks VapoSteam or Kaz Inhalant to the "mist" output:
1. Push the POWER switch to the "OFF" position and allow the Top Housing to cool.
2. Carefully add liquid medicine to medicine cup. DO NOT fill the cup more than
half full.
". NOTE: When you
";