Setup; General Use; Renting A New Locker - PC Locs LocknCharge FUYL Tower Instrucciones Para El Usuario

SETUP

Before the cabinet is powered on for the first time, use the cabinet keys to open the master control door.
Retrieve the admin keys (secured to the DB9 connector of the controller).
If the battery is already installed in the board on the top of the controller then remove the insulating tag to
enable the battery connection. If the battery is not yet installed, then install the 3V Lithium battery (found
in the parts box) into the holder on the control board, positive (large) side upward. Close and lock the
master door.
Check that the circuit breakers of both distributions boards in the base of the cabinet are on, then close and
lock the access door. Keys for the locker should be held by the person(s) responsible for the locker.
Switch on power to the locker. The controller will take approximately 30 seconds to initialise and boot, and
then all fifteen locker doors will be opened sequentially.
The lockers are now ready for normal use.

GENERAL USE

Renting a New Locker

INSTRUCTION MANUAL
The user approaches the locker and begins typing a
locker number.
When renting a new locker, the user should identify
a locker that is unlocked and make that selection.
Locker number must be 1 – 15.
Press OK to select when finished.
The user is prompted for a 4 digit PIN to lock the
door.
NOTE: If the locker was not free, the display will
indicate that the locker is LOCKED.
The PIN must be confirmed by the user and
must be a correct match before the door can be
locked.
Place mobile device in locker and connect to
charging socket.
Close the door firmly and the door will latch.
It is now safe to leave the locker.