Hardware Installation - D-Link DUB-E100 Guía De Instalación Rápida

PRODUCT SETUP

HARDWARE INSTALLATION

Step 1:
Plug the DUB-E100's USB cable into an available USB port on your computer.
Step 2:
Attach an Ethernet cable to the Ethernet port on the DUB-E100.
Step 3:
Attach the other end of the Ethernet cable to your network switch, hub, or router.
Step 4:
Windows will detect the new hardware and prompt you for the drivers.
For Windows 7 and Vista:
The driver software installation will start automatically.
For Windows XP:
The Found New Hardware Wizard box will pop up. Select Yes, this time only and click
Next to continue.
On the next screen, choose the option to install the software automatically and click
Next to continue. The driver software installation will then start automatically.
Installation Complete
When the installation of the DUB-E100 is complete, the Speed LED will be solid green when the
DUB-E100 is connected to a 100 Mbps network. The TX/RX LED indicates when data is being
transmitted or received by fl ashing amber. If both LEDs are unlit, there may be a problem with
the physical connection. Check the cables between your DUB-E100, the computer, and the
network. Verify that your network switch, hub, or router is powered on.
Speed LED
L i g h t s u p s o l i d g r e e n w h e n t h e
network connection is at 100 Mbps.
4
TX/RX LED
Flashes amber when data is
being transmitted or received.
DUB-E100