Regular Inspections - Prolux 430 755 Manual De Instrucciones

Originalbetriebsanleitung – Rangierwagenheber Alu Racing Jack 3000 kg / 2000 kg
To prevent corrosion, the Alu Racing jack should be cleaned and dried after use in a damp environment.
All moving parts must be greased regularly with bearing grease.
Regularly as required
After each oil top up
After prolonged non-use
After 3 to 6 months
Repairs
Repairs of an Alu Racing jack may only be carried out by qualified persons and are subject to the decision of the
manufacturer.
Never try to repair the product yourself.
In the event of doubt about its proper functioning, the Alu Racing jack must be removed from service for inspection by an
expert.
Also, do not use the product in the event of:
- fracture, deformation, sharp notches or cracks of any kind
- wear and excessive corrosion

Regular inspections

Perform a visual inspection before each use to detect any damage.
Damaged jacks must not be used.
Troubleshooting
Problem
The load cannot be lifted.
The load is not held in the
raised position.
The lift arm does not
reach the maximum
height.
The lift arm does not
lower completely.
Disposal
Collect used oil or leaking oil in a special container and take it to a waste oil disposal point. Dispose of the jack properly.
Warranty
The warranty expires if the product is used improperly and if the information in these operating instructions is not
observed.
Further warranty provisions can be found in the General Terms and Conditions of ProLux Systemtechnik GmbH & Co KG.
Interval
Reason
1. Drain screw not tight enough.
2. Oil quantity too low.
The oil level is too low or there is air in the
system.
The oil level is too low or there is air in the
system.
The return spring is worn out or unhooked.
Description
Top up oil
Venting the hydraulics
Venting the hydraulics
Grease all moving parts
Solution
1. Tighten the drain screw clockwise.
2. Top up with oil.
Top up oil and/or vent the system (see
section Initial operation).
Top up oil and/or vent the system (see
section Initial operation).
Have the return spring replaced by a
specialist. (Clean and lubricate moving
parts regularly.)
9
English