Hella Micro DE Instrucciones De Montaje página 10

Tools required:
Mounting dimensions:
Mounting is possible upright or
pendant above or below the
bumper. Lamps should not vibrate
or extend beyond bonnet and
should be attached symmetrically.
10
Preparation:
Seite 3:
Electrical connection
red
red/white
brown
blue
• Ruler
• Combination pliers
• Open end or box wrench, 13 mm
C D
1. Determine mounting position and
mark mounting points in
accordance with attachment
dimensions specified above.
2. Drill pilot hole with 3 mm bit and
drill out to 8.5 mm. Seal drilled
metal parts with rust protection
agent.
Install receiver with plug connection
pointing downwards so that it is
protected from splashing water and
the housing contact surface is as
large as possible.
Cleanly route antenna cable along
edge of engine compartment in the
vicinity of the transmitter and secure
• Open end or box wrench, 8 mm
• Drill with 3 mm dia. and 8.5 mm
dia. bits
• Phillips screwdriver
= Do not mount higher than dipped
beams
C
3. Pre-assemble mount and tighten
screws hand-tight.
Disconnect earth lead (-) from
battery as precaution.
with cable straps (without contact to
body if possible).
Route and connect leads as
indicated in circuit diagram.
Fasten transmitter to dashboard
with double sided adhesive tape
included.
(see also
"One more tip")