Mounting And Maintenance Rules - PRO Intellect Technology MONIRON DEC MULTI Manual De Operación

MONIRON DEC EUR
Orientation to:
Center
Right edge
Left edge
Figure 5 Figure 6
Incorrect orientation of notes
Correct orientation of notes
The detector will determine the nominal of authentic banknote (in 'Add' mode it will add
its nominal to the total sum).
Attention! If a banknote is placed in receiving tray incorrectly, the banknote is not
detected as an authentic one and any error code is displayed.
In case of error check banknote orientation (Fig.4) and try to place the banknote into
receiving tray once again.
At the end of the counting reset the display by pressing the button 'CLR'.
At the end of operation switch off the detector, holding button 'CLR' within 3 seconds
down.
4

Mounting and maintenance rules

1. When choosing a mounting place for detector, avoid uneven and water-close surfaces
and dangerous objects.
2. Do not mount and so not use the detector in places where it can be affected by direct
sunlight, strong vibration and dust.
3. Use the adapter supplied with the device.
4. If the device was kept in cold for a long time, keep it for at least 6 hours without
packing at a room temperature before switching on.
5. Switch off detector when it is not used for a long time during a day.
6. Error codes and messages.
Attention! Errors may occur when verifying authentic crumpled, dilapidated, dirty,
laundered, torn, taped, decoloured banknotes or if a banknote was exposed to hostile
environment or has foreign inscriptions.
Attention! New pattern banknotes may be issued. If there are errors in operation of
detector during banknote verification, install a new firmware in service centre. During the
warranty period new firmware is installed for free.
7