Section Iv. Stainless Steel Face Ring Assembly Instructions; Section V. Replacement Parts - Pentair Water SunBrite II Manual Del Propietario - Operador

Use only the special pilot screw provided with this underwater light.
This screw mounts and electrically grounds the housing securely to
the mounting ring and wet niche. Failure to use the screw provided
could create an electrical hazard which could result in death or serious
injury to pool users, installers or others due to electrical shock.
10. Fill pool until the underwater light is completely submerged in
water before operating the light for more than 10 seconds.
Turn on main switch or circuit breaker, as well as the switch
which operates the underwater light itself, to check for
proper operation.
Section IV. Stainless Steel Face Ring Assembly
Instructions
1. With the light resting on its base, place the gasket assembly
on top of the light shell as shown, see Figure 4. A NEW LENS
GASKET MUST BE USED EACH TIME THE LIGHT IS
REASSEMBLED. Center the stainless steel face ring and
place it over the lens and gasket assembly. The locking levers
should all be hanging freely down to install over the lens and gasket. Align the special pilot screw on the face ring with
the letter "R" of the word "Before" as used in the phrase "SUBMERGE BEFORE LIGHTING" found on the lens
surface and the compression fitting on the light shell.
2. With the bent ends of the circular uni-tension clamp pointing down spread the clamp and place it in the "U" recesses
of the locking levers. Be sure the bent ends of the clamp are located between the pair of locking levers as shown in
Figure 3, location A. Check to see that the clamp is properly engaged with all of the levers.
3. Turn the light so that it is now resting on its lens. Tighten the screw and nut until the distance between the ends of the
clamp equals 1/4 inch or less; see Figure 4.

Section V. Replacement Parts

6
Rev C • Rev C • Rév C 10-29-07
WARNING
1
2
3
4
5
7
Figure 3.
Figure 4.
Item
No. Part No. Description
1 79212100 Face ring, large plastic, white
1 79212165 Face ring, large plastic, gray
1 79212111 Face ring, large plastic, black
2 05101-0004 Pilot Screw, with captive gum washer
2 79104800 Pilot Screw, with captive gum washer, Si Br
2 619355 Pilot Screw, with captive gum washer, S/S
3 619677Z Face Ring Kit, S/S
4 79111000 Uni-tension wire clamp assy.
5 600055 Lens Kit, SunBrite II
6 79101601 Gasket, 8-3/8 in. lens
7 79131000 Bulb, 300 watt, 120 volt, double-ended T3 R7S
7 79131400 Bulb, 50 watt, 12 volt, 2 Pin T3 GY 6.35
7 79131200 Bulb, 100 watt, 12 volt, 2 Pin T3 GY 6.35
78900700 Kwik-change lens cover, green
78900800 Kwik-change lens cover, blue
78900900 Kwik-change lens cover, red
78901000 Kwik-change lens cover, amber
Used with Fixture Housing P/N's 05161-XXXX & 05163-XXXX,
and Pentair Large Niches.
7
45 degrees
Bolt and nut are to be tightened at approx. 45 degrees
from the pilot screw between the tabs on the face ring
as shown above.
P/N • Núm/Pte. • Réf. 619692
A