Machine Operation - GYS EASYCUT 40 Manual De Instrucciones

2 - INSTALLATION OF THE TORCH CONSUMABLES :
Before changing the consumables, cut the power supply using the interrupor behind the machine.
To use the torch, a complete set of consumables must be installed in the correct order: electrode, diffuser, tip and nozzle.

MACHINE OPERATION

1 - PLACE THE EARTH CLAMP ON THE PART TO CUT
Ensure proper electrical contact and do not to put the cable on the cutting trajectory.
Warning: painting prevents contact between the metal part and the earth clamp, do not forget to sand.
2 - CHECK THE PRESENCE OF ALL THE CONSUMABLES ON THE TORCH AND CONNECT AS FOLLOWS :
3 - START THE MACHINE and check that the power light (1) is on.
4 - SETTINGS PANEL (FIG-2)
Green light (1) «ON»
When the machine is switched on the light turns on. In case of power failure, the green light goes off but the device remains powered while the power
cable is unplugged.
Orange light (2)
Over-temperature: in such a case, the orange light will flash once per second. You shall wait a few minutes, the light will turn off and the machine
will start to work again.
Over-current on primary circuit: in such a case, the orange light will turn on all the time. You shall switch off the machine (with the main switch) and
switch on.
Orange light (3)
No connection of torch: in such a case, the orange light will turn on all the time. You shall check the connection of torch and the protection shroud.
No gas or Not enough pressure: in such case, the orange light will flash once per second. You shall check the gas and adjust the pressure of gas
more than 2.5 bar and you also need to check the tailpipe was not twisted.
5 - SETTING FOR THE AIR PRESSURE (FIG-2)
Push the button et select
6 - CURRENT SETTING (FIG-2)
Use the adjuster to set the current relative to the thickness and type of the metal sheet. Refer to the «guideline printed on the serigraphy of
cutting the machine
7 - STARTING THE CUTTING MODE (FIG-2)
Push the button and select
EASYCUT 40
Nozzle Tip
. Choose the air pressure between 2.5 and 6.5 bar.
to begin cutting.
Diffuser Electrode
Insert the torch's connector (A) in the female compartment (E) and
screw the B part. Be careful to tighten the torch.
To remove the torch, unscrew in the same manner as above.
EN
Torch
17