Starting And Stopping; Stop The Engine - Senix CSP4QL-L Manual Del Operador

Podadora de altura a gasolina con motor de 4 ciclos de 1.62 pulg. cúb. (26.5 cc)
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STARTING AND STOPPING

To start a cold engine:
1. Slowly press the primer bulb 5-10 times.
NOTE: After the 7th press, fuel should be visible in the
primer bulb. If it is not, continue to press the primer until
you see fuel in the bulb.
2. Push the choke button in to set the choke to FULL
CHOKE position.
NOTE: Do not squeeze the throttle trigger because the
choke will be pop out automatically.
3. Pull the starter grip /cord until resistance is detected.
Rapidly pull 3 to 5 times or until you hear engine turn
over or begin to start.
4. If engine does not start, release choke by squeezing
throttle trigger and choke button pops out.
a.Engine is now in the run position.
b.Rapidly pull starter grip/cord until engine starts.
5. Allow the engine to run for 10 seconds,then squeeze
throttle to provide fuel to engine and use for intended
task.
NOTE: The choke button is only used when starting
a cold engine. Never push the choke button in once
the engine has been turned over or run. Otherwise the
engine could be damaged.
Restart a warm engine:
NOTE: DO NOT push choke button in.
1. Make sure the primer bulb has fuel inside.
2. Rapidly pull starter/grip until engine starts.
3. Squeeze throttle to provide fuel to engine.

STOP THE ENGINE:

To stop the engine, depress the STOP switch to the
stop position "STOP".
NOTE: This Stop switch will come back to the ON
position automatically.
IF ASSISTANCE IS REQUIRED FOR THIS PRODUCT:
Do not return this product to the retail store where it
was purchased. Please call our Customer Service
Department for any issues you may have. For Help
Call: 1-800-261-3981
HOLDING THE UNIT
• Stand in the operating position Stand up straight. Do
not bend over.
• Keep feet apart and firmly planted.
• Hold the shaft grip with the right hand. Keep the right
arm slightly bent.
• Hold the handle with the left hand. Keep the left arm
straight.
• Hold the unit at waist level.
• Position the cutting head a few inches above the
ground.
• Do not over-reach; Keep all parts of your body away
from the rotating cutting attachment and hot surfaces.
WWW.SENIXTOOLS.COM
On/Off Switch
(I = On / STOP = Off)
Throttle Control
Primer Bulb
Choke
Starter Rope Grip
Throttle Control
Throttle
Lockout
Starting
Position
13

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido