Standard Accessories; Battery Removal/Installation - Hitachi FDS 9DVA Instrucciones De Manejo

English
SPECIFICATIONS
POWER TOOL
Model
No-load speed (Low/High)
Wood
(Thickness 18mm)
Drilling
Metal
(Thickness 1.6mm)
Capacity
Machine screw
Driving
Wood screw
Rechargeable battery
Weight
CHARGER
Model
Charging time
Charging voltage
Gewicht

STANDARD ACCESSORIES

1 Plus driver bit (No. 2 55L) ........ 1
2 Charger (UC9SD) ............................ 1
FDS9DVA
3 Plastic case ....................................... 1
1 Plus driver bit (No. 2 55L) ........ 1
FDS12DVA 2 Charger (UC12SD) ........................... 1
3 Plastic case ....................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Battery (FEB9S) (For FDS9DVA)
2. Battery (FEB12S) (For FDS12DVA)
Optional accessories are subject to change without notice.
4
All manuals and user guides at all-guides.com
FDS9DVA
0 – 280 / 0 – 840/min.
18 mm
Steel: 10 mm,
Aluminum: 12 mm
6 mm
5.5 mm (diameter) × 45 mm (length)
(Requires a pilot hole)
FEB9S: Ni-Cd 9.6 V
1.5 kg
UC9SD
9.6 V
1.2 kg
0 – 350 / 0 – 1050/min.
5.5 mm (diameter) × 63 mm (length)
(Requires a pilot hole)
FEB12S: Ni-Cd 12 V
Approx. 1 hour (at 20°C)
APPLICATIONS
Driving and removing of machine screws, wood
screws, tapping screws, etc.
Drilling of various metals.
Drilling of various woods.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the driver drill, charge the battery as
follows.
1. Insert the battery in the charger.
Position the battery so that the nameplate faces
toward the nameplate of the charger and press in
the battery until it comes into contact with the
bottom surface. (See Figs. 1 and 3)
2. Connect the charger power cord to the receptacle.
Connecting the power cord will turn on the charger
(the pilot lamp lights up).
CAUTION
If the pilot lamp does not light up, pull out the
power cord from the receptacle and check the
battery mounting condition.
About 1 hour is required to fully charge the battery
at a temperature of about 20°C. The pilot lamp goes
off to indicate that the battery is fully charged.
FDS12DVA
21 mm
Steel: 12 mm,
Aluminum: 15 mm
6 mm
1.6 kg
UC12SD
12 V
1.4 kg