Maintenance And Storage - Ribimex Ribiland PRBAT20/TH Manual De Instrucciones

- Both sides of the cutting blades allow to trim both ways: from right to left or left to right (Fig.B).
- To achieve a regular trim, we recommend you limit the side of the hedge with a wire or line. Only
the branches higher than the top of the wire or line should be cut (Fig.C).
- The sides of a hedge should be trimmed from bottom to top (Fig.D).
Fig.B Fig.D
Fig.C
Fig.A
Important :
- Large branches should be cut with shears.
- In case the blades get blocked, stop the hedge trimmer and remove the battery. Then, proceed to
clear the blockage.
VI. MAINTENANCE AND STORAGE
Before any intervention on product, switch off tool and remove the battery
Reminder: Make sure to maintain the machine in good working condition, carry out regular
maintenance of the machine after each use and before storage.
Any breach or default of adequate maintenance reduces the life of the machine and increases the risk
of breakdowns and accidents.
To preserve the security system throughout the life of the machine, it is important to perform
maintenance and proper cleaning, DO NOT use non-compliant replacement parts and do NOT
dismantle yourself the machine or change the security features.
6.1- Maintenance
- Always wear gardening gloves when handling or working near the spool.
- Check your machine regularly before starting any work. Check the machine carefully and replace
worn or damaged parts for safety.
- Keep all nuts, bolts and screws tight to be sure that the machine is in safe working condition.
- Damaged tool has to be repaired or exchanged by a qualified person before working with the
machine.
- Do not attempt to repair the machine yourself, to avoid any danger.
- Only use original accessories and spare parts.
6.2- Cleaning
a) Clean the plastic parts with a soft and clean cloth and dry the housing carefully.
Do not use aggressive cleansing agents (solvents, abrasive cleansers) or an abrasive sponge or any
sharp objects.
- Do not use any caustic chemicals to clean the plastics parts.
- Never put or immerse the product in water or any liquid, and ensure that water does not penetrate the
tool. Never splash with water or clean with high pressure hose! Do not clean under running water.
b) After each operation, clean the tool.
c) Always keep the ventilation slots in motor housing clean. Clean ventilation holes with soft brush.
Page 29 / 78