Main Applications - Genio 050149 Manual De Instrucciones

User Manual EN
Important Information
Please read, understand and follow all safety information
contained in these instructions prior to the use of this tool. Retain
these instructions for future references.
Foreword
We are a manufacturer and exporter of air tools since established.
We have devoted all our efforts in improving quality and tools'
life. As well as the noise and vibration of tools. Bring all of you
working efficiencies, profits, and enjoy using the tool is our
principle.
Features
1. Finishing of flat wide surfaces.
2. The grinding speed can be freely adjusted by raising or
lowing the lever according to the application.
Model RPM Pad Spindle
size Thread
(in.)
6320 13000 1 x 2 1/4
Warning
1. This tool is not appropiate for coming into contact with electric
power source.
2. It is forbidden to use this tool in explosive atmospheres and do
not put any combustible material near the workpiece since it
emit sparks when it grinds with metal material.
3. Prevent long hair or loose clothing from drawing in while
operating this tool.
4. Never carry the tool by hose and beware of a whipping
compressed air hose.
5. Rotating action can cause this tool to become hot. Allow to
cool and disconnect air hose before any changing or adjusting
6. It is not designed for wax polish.
4
Orbit Weight Length Air Rec. Hose
off-set (lbs.) (in) Cons. Size (in.)
(in.) (CFM)
1/8 500 165 2.5 3/8
Operator's instruction

1. Main Applications

Durability, versatility and power make this highspeed sander
excellent for paint removal, shaping filler patches, weld
smoothing, and rust removal. Ability to precisely control speed
makes this tool useful for a variety of surface conditions and
contours.
2. Cautions for Use
2.1. Air line
Tools of this class operate on a wide range of air pressure. It is
recommended that air pressure of these tools measures 90 PSI
while running free. Higher pressure and unclean air will shorten
the tool's life because of faster wear may create hazardous
condition and void the warranty. Water in the air line will cause
damage to the tool.
2.2. Air hose
Clean the hose with a blast of compressed air before connecting
the hose to the air tool. This will prevent both, moisture and dust
within the hose from entering the tool and causing possible rust
or malfunction. To compensate for unusually long hose (over 25
Air Inlet
(in.)z
ft), the line pressure should be increased accordingly.
1/4 NPT
2.3. Sandpaper
The specification of sandpaper is variable. Also note that the
operating speed which the sandpaper can reach shall be higher
than the rotation speed of this tool.
2.4. Protections
The approved eye protector, ear-muff, mouth-muffle, and gloves
shall be worn when operate this tool.
2.5. Working Place
The working place shall be ventilated.
2.6. Energy supply failure
Release the on-off device in case of energy supply failure.
3. Operation, Adjusting And Replacing Method
3.1. On-off device
The on-off device is on the top of this tool. It is a "hold-to-run"
type. You can alsoadjusting the running speed by raising or
lowering the lever. This tool stops rotation within a few seconds,
after releasing the lever. For the sake of safety, put it on a soft
cloth or on hanger after it completely stops.
3.2. Sand pad
If the sanding pad is no longer adhesive, you should change
to a new one. To change it, turn up the shroud and insert
the supplied wrench to fix the screw bolt in the central
then turn the pad as shown in the illustration below.