Important Safety Instructions - Premier SX-4246TVD Manual De Instrucciones

Option: Change-Select it to change password.
Procedure to change password as following:
1) Enter old password in the Old Password row
2) Enter new password in the New Password row
3) Enter the new password again in the Confirm Pwd row
The user password is "0000". You may reset the password if you forget the old password by using the
supervisor password: 1389
4.7 DEFAULT - Reset to factory settings.
DISC HANDLING PRECAUTIONS
! Hold the disc by the edge so the surface will not be soiled with finger prints. Finger prints,
dirt and scratches can cause skipping and distortion.
! Do not write on the label side with a ball-point pen or other writing utensils.
! Do not apply benzine, thinner, and liquid that prevents against static electricity.
! Be careful not to drop or bend the disc.
! Install only one disc on the disc tray.
! Do not try to close the disc tray when the disc is not installed properly.
! Be sure to store the disc in its case when not in use.
SPECIFICATIONS
Power source: AC 100-240V~ 50/60Hz
DC: 9V-12V
Power consumption: 11W
Operating Temperature Range: +5°C to +35°C
Continuous playing time: 120 minutes
Dimensions: 248(L) x 185.7(W) x 39.2(H) mm
Operating Humidity Range: 10 % to 75 %
TROUBLESHOOTING
If your DVD player does not seem to be functioning properly, check the items below before you contact
an authorized service center.
Symptom
Power does not turn Make sure the AC/DC adapter is securely plugged into an AC
!
on or suddenly turns outlet.
off. Turn the power off and then back on.
!
No picture or sound Check that the A/V cables are securely connected.
!
Check that the disc is a DVD, DVD-RW or AUDIO CD.
!
Do not use a disc that has scratches or dirt.
!
Check that the label-side of the disc is facing up.
!
The pick-up lens of the DVD player may be dirty. Contact the
!
service center for lens cleaning.
Check that the TV channel is set to VIDEO or AV if viewing with a
!
P-10
Check
TV.
No sound Check that the display panel is open. If it is closed, audio will not
!
be output to the speakers.
Check the volume setting. If set to zero, turn up volume level.
!
Check that the headphones are plugged into the PHONE socket.
!
Speakers cannot be used with the headphones.
No picture and sound Check the AC/DC adapter is properly connected.
!
Distorted video or Use a disc without scratches or dents.
!
sound

IMPORTANT SAFETY INSTRUCTIONS

! The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids,
such as vases, shall be placed on the apparatus.
! When AC/DC adapter is used as the disconnect device, the disconnect device shall remain readily
operable. To be completely disconnected the power input, the AC/DC adapter shall be disconnected
from the mains completely.
! No naked flame sources, such as lighted candles, should be placed on the apparatus.
! Minimum distances 2.0cm around the apparatus for sufficient ventilation. The ventilation should not
be impeded by covering the ventilation openings with items, such as newspapers, table-cloths,
curtains, etc.
! The use of apparatus is in tropical and/or moderate climates.
! Attention should be drawn to the environmental aspects of battery disposal.
! CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
! Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
! Excessive sound pressure from earphones and headphones can cause hearing loss.
! The marking plate is located at the bottom of the apparatus
P-11