Publicidad
Idiomas disponibles
Idiomas disponibles
still in "Run" Mode, as long as the Power Supply is
turned "ON". Any setting for the Maximum Speed will
be stored while the Power Supply is turned "ON".When
the Power Supply is turned "OFF", the setting will be
kept at the last time you used when the Power Supply
is turned "ON" again.
MAXIMUM SPEED AND INTERMEDIATE SPEED
CONTROL
1. Maximum Speed is adjusted by pressing the " + " or
"—" buttons on the back of the Sander. While the
Sander is in "Run" Mode, each touch will raise or
lower the speed to the next setting.
2. In the default mode the speed can be adjusted
linearly by adjusting the position of the lever.
SOFT START FUNCTION
The sander has the soft start function that prevents
gouging of the work surface.
OVERLOAD PROTECTION SYSTEMS
The Sander is equipped with Downforce Overload
System. During periods of overly high user downforce,
the sander LED will flash"red" color and cause the
motor to slow slightly as a warning to the user, and to
maintain the most efficiency spinning power under the
condition of overload. Continuous downforce should be
no greater than approximately 3 Kg.
If the user continues with overly high downforce
greater than 3 Kg, the sander will change
the LED flashes"red and green" alternately and stop.
To restart the sander immediately, released the lever
and pressed down again and continue sanding.
Repeated overloading will result in frequent motor
stops and increased tool temperature.
Temperature Overheat System
The Sander has the ability to monitor temperature
of the internal electronic systems, and can shut the
tool down when temperature reach damaging levels.
During periods that result in high internal temperature,
the Sander will shut down if the temperature reaches
a damaging level. The Sander will not be able to
be restarted until the internal temperature cools
to a level safe for the electronic systems. Cooling
time depends on local conditions. An initial waiting
period of 5 minutes is recommended. Repeated
overheating will result in longer cool down times.
ATTACHING DISC PADS
Disc Pads are specially designed to mate to the Electric
Random Orbital Sander.
1. Secure the Spindle with the flat wrench provided
with the tool, and screw the Disc pad on. Tighten to
firm hand-tightness. Do not over tighten.
2. To remove the Disc Pad, insert the flat wrench
between the Disc Pad and shroud. Secure the
Spindle with the flat wrench and unscrew the Disc
pad.
CLEANING
1. Periodically blow out all air passages and area above
Disk Pad and under shroud with dry compressed air.
All plastic parts should be cleaned with a soft damp
cloth. NEVER use solvents to clean plastic parts.
2. Wear safety glasses while using compressed air.
Manual EN
19
Publicidad
