Cleaning And Maintenance - VelLight LEDA310 Manual Del Usuario

• Familiarise yourself with the functions of the device before actually using it.
• All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to
the device is not covered by the warranty.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
lamp explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
• Use the original packaging if the device is to be transported.
• Keep this manual for future reference.
4. Features
• floodlight for commercial or residential use, entry monuments or façades
• die-cast aluminium housing with tempered glass
• ribbed for maximum heat dissipation
• with adjustable bracket
• suited for outdoor use (IP65).
5. Overview
Refer to the illustrations on page 2 of this manual.
1 protective glass
2 LED
6. Installation
Guidelines
• A qualified technician should install and service this device.
• The construction to which the device is attached should be able to support 4 times the weight of the device
for one hour without deformation.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper installation may result in serious injuries.
• Do not fix the device to flammable surfaces.
• This device is not suitable for dimming.
Distances
• Keep the device at least 20cm away from ceilings or walls.
• Respect a minimum distance of 1m between the device's light output and any illuminated surface.
Mounting the Lamp
1. This luminaire does not have a built-in device to disconnect it from the electric mains. Make sure to
electrically isolate the luminaire before installation or maintenance activities are performed.
2. Use the mounting bracket [4] to determine the location of the mounting holes.
3. Drill the holes and secure the bracket using 2 screws and wall plugs.
4. Connect the power cable [5] to a suitable junction box [6] (not incl.). Make sure the connection is properly
earthed. Make sure there is no strain on the cable; leave sufficient slack.
Warning: if the power cable is damaged, it must be replaced by the manufacturer, his service agent, or a
similar qualified person in order to avoid any hazard.
5. To point the lamp in the desired direction: loosen the hinges [3] using a 6 mm Allen key.
6. Tilt the lamp in the desired angle and tighten the hinges.
7.

Cleaning and Maintenance

• All screws should be tight and free of corrosion.
• The housing, the visible parts, the mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with; e.g. do not drill extra holes in mounting
supports, do not change the location of the connections...
V. 01 – 18/07/2012
LEDA310/311/312
3 hinge
4 mounting bracket
4
5 power cable
6 junction box (not incl.)
©Velleman nv