Blackmagic Design ATEM Mini Manual De Instrucciones página 110

Assigning an input to a HyperDeck
In the first menu page, you'll see the 'HyperDeck' indicator in the bottom left corner, and an
'input' indicator.
Use the control knob under the 'HyperDeck' indicator to cycle through the available
HyperDecks.
Once you have selected a HyperDeck, simply rotate the knob under the 'input' indicator to
select which input that HyperDeck is connected to on your switcher. For example,
if HyperDeck 1 is connected to input 4 on your switcher, rotate the knob under the 'input'
indicator to select 'camera 4.' Press the 'input' knob to confirm your selection.
Assigning an IP Address
Once you've assigned an input to a HyperDeck, you'll need to enter its IP address.
This allows ATEM 1 M/E Advanced Panel to control the HyperDeck via Ethernet.
To enter a HyperDeck's IP address, navigate to the third HyperDeck settings page with the
'left' or 'right' arrow buttons, or pressing '3' on the numeric keypad while in the HyperDeck
settings menu.
In this page, you'll see an IP address for the currently selected HyperDeck. Each IP address
number corresponds to a rotary knob below it. To change these numbers, you can rotate the
corresponding knob, or press the knob once and enter a number using the numeric keypad.
Do this for each number in the IP address.
Once you've entered the IP address for your HyperDeck, press the soft button corresponding
to the 'save changes' indicator to confirm the address. To cancel, press 'undo'.
Auto Roll
You can toggle your HyperDeck's auto roll function from the second screen of the HyperDeck
settings menu. While in the HyperDeck settings menu, use the 'left' or 'right' arrow buttons in
the system control panel to navigate to this screen.
Repeat this process for
any additional HyperDecks
you have connected to
your switcher by assigning
inputs to HyperDeck slots
1, 2, 3 and 4, if required.
To enter the IP address
for subsequent
HyperDecks, you'll need
to select the HyperDeck
using the first page of the
HyperDeck settings menu.
HyperDeck Control 110