Installation Instructions; Freestanding Installation; Handle Installation - Haverhill HHE1500M1 Manual De Uso Y Cuidado

INSTALLATION INSTRUCTIONS

Freestanding Installation

1� Gently lay the heater on a table or countertop. The front of the heater should be facing up, with
its base hanging over the edge of the table or countertop.
2� Clip the left and right feet to the base of the heater by aligning the seams of the feet to the
respective slots shown on the base. Using a downward motion (i.e. top to bottom), slide the feet
onto the base until they lock into place.
3� Gently turn the heater right-side up and place it onto the ground�
NOTE: The feet can only be installed to the heater using one direction; they are not interchangeable.

Handle Installation

a b
Rear of the Heater
a. Cylindrical groove for handle
b. Wall mounting slot
c. Wall mounting slot
d. Cylindrical groove for handle
1� Locate the 2 cylindrical grooves on each of the upper corners from the rear of the heater. These
grooves are adjacent to the wall-mounting slots.
2� Insert one end of the handle into the groove, and then pinch the arms of the handle together
when inserting the other end into its respective groove.
3� Repeat Step 2 for the remaining handle�
4� The handles are now fixed to the rear of the heater.
c d
6