Virutex AB111N Manual De Instrucciones página 6

8.2 JOINTING AT AN END
For all board thicknesses use the movable front
panel and the movable fence.
Position the front movable panel at the desired
height or board thickness. Place the movable fen-
ce panel in the 90° position and mill the slot (Fig.
13 and 14). Glue and assemble (Fig. 17).
Maximum displacement of the movable front
panel over the centre of the blade tool is 45
mm. (Fig. 15 and 16).
8.3 MITRE JOINTING
For all board thicknesses and angle, use the
movable front panel and the movable fence
(Fig. 18 and 19). Example: 45° MITRE JOINT.
Position the front movable panel at the desired
distance and the movable fence at 45° (Fig. 20
and 21). Glue and assemble (Fig. 22).
8.4 FRAME JOINTING
Frames can be mitre or square jointed. Two
splines are recommended if the thickness is
greater than 25 mm. (Fig. 23, 24, 25).
8.5 LENGTHWISE JOINTING
For lengthwise jointing, the movable front panel
should be set at board thickness. Proceed as
indicated in fi gures (Fig. 26, 27, 28).
9. STARTING UP THE MACHINE
To start up the machine, push button R forward
(Fig. 14) to the on position.
To stop the machine, simply press the back of
the switch and it will return to the off position.
10. CHANGING THE DISC
WARNING! Unplug the machine from the
electrical outlet before any maintenance
6
All manuals and user guides at all-guides.com
operations.
Remove the cover A fi xing bolts (Fig. 29).
Separate the base from the machine body
(Fig. 30).
Remove the disc with the wrench, as shown
in (Fig. 31).
Clean the seat and follow the instructions for
assembly in reverse order (Fig. 32).
11. DEPTH ADJUSTEMENT
WARNING! Unplug the machine from the
electrical outlet before any maintenance
operations.
Put the depth regulator in the nº 20 position
and set the disc outlet at 12 mm with the nuts,
maintaining the machine in the cutting position
(Fig. 33 and 34).
To check the depth, cut a groove, insert a piece
of board and mark with a pencil. Turn it over and
check that the mark coincides. If not, correct the
defect by adjusting the nuts. (Fig. 35).
Recommendations:
Keep the machine clean and lubricate the guides
periodically. They should never be left dry (Fig.
36 and 37).
12. MAINTENANCE OF BRUSHES
AND COLLECTOR
WARNING! Unplug the machine from the
electrical outlet before any maintenance
operations.
Remove screws B (Fig. 384) that fasten the side
covers and detach both.
Remove the brush-holder H (Fig. 39) with small
screwdriver G, using one of the brush-holder
side tabs to lever it out.
Push back the end of spring C.
Keep it in this position to extract the brush and
replace it with a new genuine Virutex brush.
Reinsert the brush-holder, ensuring that it is
fi rmly positioned in the casing and that each of
the brushes exerts a small amount of pressure
on the collector.
Re-attach the covers F with the corresponding
screws, making sure that no wires get caught
in the process.
It is advisable to leave the machine running
for 15 minutes once the brushes have been
changed.
If the collector burns or juts out, it should be
serviced by a Virutex service technician.
Keep the lead and plug in good working con-
dition.