KEY
1 Boiler body
2 Burner
3 Burner manifold
4 TCB M5 x 8
screw
5 Aluminium
washer ø 14
6 Burner nozzle
2. 1 1
ASSEMBLING THE SKIRT
Proceed as follows to assemble the skirt
(fig. 11):
– Position the front and back supports of
the skirt base (1) between the feet on
KEY
1 Front and rear skirt base support
2 Right skirt base support
3 Left skirt base support
4 Lower left side rear panel
5 Upper right side rear panel
6 Front left side panel
7 Rear lower right side panel
the two heads.
– Anchor the side supports (2) and (3) to
the front and back of the skirt base (1)
with the M6 nuts supplied.
– Anchor panel (4) to panel (5) and panel (7)
to panel (8) using the connecting pins.
8 Rear upper right side panel
9 Front right side panel
10 Cover
11 Lower front wall
12 Upper front wall (cleaning plate)
13 Rear wall
14 Baseboard
15 Door
– and panels (7-8) to panel (9) using con-
necting pins, anchoring them together
wit h two 7SP x 1/2" self-t apping
screws.
– Assemble panels (4) and (6) on the base
(3) , anchoring them on connecting pins.
Proceed in the same way to anchor
panels (7) and (9) to the base (2).
– Position the lower front wall (11) by fit-
ting it in between the screws on the bur-
ner manifold support brackets and the
cast iron body; anchor the walls to
panels (6) and (9) with two 7SP x 1/2"
self-tapping screws.
– Position the upper front wall (12) by
anchoring it to panels (5-8) and to wall
(11) using four 7SP x 1/2" self-tapping
screws.
Fig. 10
– Anchor the rear wall (13) to panels (4-5)
and (7-8) using the eight 7SP x 1/2"
self-tapping screws supplied.
– Assemble the baseboard (14), ancho-
ring it to panels (6) and (9) using connec-
ting pins.
– Proceed in the same way to anchor the
upper front panel (16) in place.
– Assemble the cover (10) and the door (15).
16 Upper front panel
NOTE:
The position of rings (6) and (9) may
be inverted, though the ring with the
slit must always be positioned on the
side where the gas assembly exits.
Fig. 11
59