Setting The 1-Hour Timer; Adjusting The Air Flow Direction; Operation Without The Remote Control Unit; Care And Cleaning - Technibel Climatisation KPAV 128 C5TA Serie Instrucciones De Uso

SETTING THE 1-HOUR TIMER

This function causes the unit to operate for one hour at the set
conditions, regardless of whether the unit is on or off.
TIMER SETTING PROCEDURE.
• Press the 1 HR TIMER button. The 1-HOUR ON TIMER mark
will appear on the display .
EG
1-HOUR TIMER cancellation procedure.
• Press the ON/OFF button to turn the air conditioner off.
• Wait for the indoor unit to stop operating.
• Press the ON/OFF button again to turn the air conditioner on.
DISPLAY AFTER THE SETTING OPERATION
NOTES
• If the 1-HOUR TIMER button is pressed after a certain time
is elapsed from the setting operation, the 1-HOUR timer
function is activated again.
COMBINING THE 1-HOUR TIMER AND THE DAILY PROGRAM
• The 1-hour timer can be activated after the daily program
setting.
• If the 1-HR TIME is pressed with the TIMER set in OFF
( sign on the display) this setting will be cancelled as
the 1-HOUR TIMER is activated, the air conditioner runs for
1 hour and then it stops.

ADJUSTING THE AIR FLOW DIRECTION

HORIZONTAL (manual)
The horizontal air flow can be adjusted by moving the vertical
vanes to the left or right, as indicated in the following figures for
each model.
VERTICAL (with remote control unit)
Make sure that the remote control unit has been turned on. Press
the FLAP button to start the flap moving up and down. If you want
to stop the flap movement and to direct the air in the desired
direction, press the FLAP button again.
CAUTION
Set vertical vanes to the front position during COOLING/DRY
operation if humidity is high.
If the vertical vanes are set to the left-most or right-most
position, condensation will form around the air outlet and
drip off.
CAUTION
Do not move the flap with your hands when the air conditioner
is running.
VERTICAL VANE
HOW TO ADJUST THE FLAP DIRECTION
« A »
« B »
for cooling and dehumidifyng
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
If you have lost the remote control unit or it has troubles, follow
the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner, switch the operation
selector to the OFF position, and then to the ON position.
NOTE
The set temperature, and fan speed are automatically set at
the last selection before stopping.
2. WHEN THE AIR CONDITIONER IS RUNNIG
If you want to turn off the air conditioner, switch the OPERATION
SELECTOR TO the OFF position.
NOTE
Power failure during operation.
In the event of power failure, the unit will stop. When the power
is resumed, the unit will restart automatically after 3 minutes.

CARE AND CLEANING

For safety, be sure to turn the air conditioner off and also to
disconnect the power before cleaning.
Do not pour water on the indoor unit to clean it. This will damage
the internal components and cause an electric shock hazard.
FLAP
CASING AND GRILLE (INDOOR UNIT)
Clean the casing and grille of the indoor unit with a vacuum cleaner
brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with a mild
liquid detergent.
When cleaning the grille, be careful not to force the vanes out of
place.
8
« B »
Zone «A»
OFF
ON
TEST
OPERATION
SELECTOR
WARNING
« A »
40°
Zone «B»
for heating