Waeco MagicSafe MS620 Instrucciones De Montaje Y D’uSo página 54

MS-620.book Seite 54 Dienstag, 18. Oktober 2005 3:04 15
Installing MagicSafe
➤
Screw the control device securely to the vehicle with the screws supplied or use dou-
ble-sided adhesive tape.
6.3 Installing the status LED
➤
Drill a hole with a diameter of 8 mm in the dashboard or in a plastic cover already
installed in the vehicle.
➤
Guide the status LED cable through the drill hole and insert the status LED in the drill
hole until it latches into place.
✓
The status LED is secured against slipping out with a small hook.
➤
Lay the cable to the control device and insert the plug in the two-pin P3 connection
(see Fig. 6, page 6).
6.4 Installing the alarm siren
The alarm siren can be mounted in the engine compartment.
When mounting it, ensure that the installation location is
– Not in an area exposed to splashing water
– Not near the exhaust system
– Cannot be accessed from underneath the vehicle, to ensure that it cannot
be sabotaged.
➤
Mount the alarm siren with the acoustic horn facing downwards.
➤
Connect the black cable (negative wire) of the alarm siren to the negative terminal of
the battery.
➤
Connect the red cable (positive terminal) of the alarm siren to the brown cable of the
P1 main cable tree.
6.5 Installing the shock sensor
➤
Select a suitable installation location on the hinge pillar.
➤
Screw the control device securely to the vehicle with the screws supplied or use dou-
ble-sided adhesive tape.
6.6 Installing the bonnet contact switch
This switch need only be installed if the vehicle does not already have one.
➤ Find a suitable location in the engine compartment and drill a hole with a diameter of
8 mm.
➤
During installation ensure that the distance to the closed bonnet is a minimum of
22 mm and a maximum of 27 mm.
Use putty to check this distance.
You can further reduce the minimum distance by shortening the switch.
➤
Test the switch function after installation.
54
MagicSafe MS620