Running The Descaling Program - AEG CF Serie 2 Instrucciones De Uso

g
0 Press the "On/Off" key (Fig. 3, h)
switch the coffee machine on.
0 Turn the coffee bean container to the
"Ground Coffee" position
Wait until the mechanism has set up
and all the lights of the Coffee Quan-
tity indicator are illuminated.
0 Pull the emptied grounds container out
until it is under the coffee dispenser
(Fig. 39).
It is used to collect the cleaning liquid.
The "Empty grounds container" indica-
tor (Fig. 3, j)
illuminated for as long as the grounds
container is pulled out.
0 Place a cleaning tablet in the ground
coffee filler (Fig. 40).
0 Press the "Clean" key (Fig. 3, f)
3 seconds. The indicator changes from
flashing to constantly on. The program
starts. The cleaning program must not
be interrupted.
During the cleaning process, the
3
"Empty grounds container" indicator
(Fig. 3, j)
gram runs six cycles with cleaning liq-
uid. The standing times are used to
allow the cleaning tablet to penetrate.
In the event of a power failure or
interruption, the program must be
restarted!
The cleaning process finishes after
approximately 8 minutes, when the
"Clean" key (Fig. 3, f)
comes on and the "Empty grounds
container" indicator (Fig. 3, j)
flashes.
0 Empty the coffee grounds container
and re-insert it. The
now goes out.
0 Turn the coffee bean container to the
desired position and fill the water tank.
The coffee machine is now ready for
use.
After running the cleaning program,
3
you are advised to throw away the first
cup of coffee from the machine.
40
(Fig. 38).
comes on and remains
is illuminated The pro-
indicator
indicator light
to

13.6 Running the Descaling Program

The descaling program allows you to
simply and effectively descale your
coffee machine. The coffee machine
should be regularly descaled, every 4-6
months, but no later than when the
"Descale" key (Fig. 3, e)
flashes.
1 Note! Formic-acid-based lime scale
solvents must not be used. Use only
AEG descaling tablets. AEG cannot
accept any liability for any damage
caused by the use of other descalants.
Do not, under any circumstances, use
vinegar, citric acid, amidosulphuric
acid or descalants containing ami-
dosulphuric acid, as these can damage
the coffee machine. The use of powder
for
products is not recommended. Descal-
ing tablets can be obtained from your
dealer (E-No. 900 195 537/7) or from
an AEG Customer Service Centre.
The descaling process runs over
two phases, lasting a total of
45 minutes, and must not be inter-
rupted.
Phase 1: descaling phase with 12
cycles, and Phase 2: flushing phase.
Between the two phases, the coffee
grounds container must be emptied
and the water tank refilled with
water. In the event of a power failure
or interruption, the program must be
restarted!
Phase 1: Descaling
0 Before starting the descaling program,
clean the coffee-making unit (refer to
„Cleaning the Coffee-making Unit"
Page 39) and empty the coffee grounds
container.
0 Pour about 400 ml warm water into
the water tank to just below the lips of
the tank lid, and place a bag (2 descal-
ing tablets) in the water tank (Fig. 41).
0 Put the water tank back in place when
the tablets have dissolved. This takes
approximately 5-7 minutes.
indicator