Setting Up Of The User Data - HMM Diagnostics ANT+ smartLAB Operación Manual

andfinallyshowsyourbodyweightonthedisplay.Nowyoucanleave
the tread of the scale. The scale will deactivate automatically after
several seconds.

Setting up of the user data

In order to measure the adipose content and other parameter you first
havetoinsertyourindividualuserdata.Youcanstoreupto8userprofiles
and recall the measured data.
The smartLAB
®
the  automatic transfer of user profile information and function setup
information. It is required that the receiving devices supports these
functions. This automatic setup function is supported by Apps and
Gateways by HMM.
With the automatic setting of the scale there is no need to setup the scale
manually. When you use the scale for the first time or you change the
batteries,thescalewillcheckforanadequatereceivingdevice.Profileand
setup information is also transferred after each data transmission to the
receiving device.
If a receiving device is in reach of the scale, it will send all the setup data
to the scale. This function has the benefit of also sending the batterie
status to the receiving device.
The automatic setting can be disabled with the function setup (Heart
Beat) (please refer to the section function setup).
If you want to set up the scale manualy please press "SET" (on the side of
yourscale)tocreateanewuserprofile.
Note: The weight scale can be set by the touch function, which can be
found on the right top side of the scale. The touch function represents the
buttons, which are abreast of the Set writing and the arrows at the side
of the scale.
User profile:
The display now shows several illuminated preadjustments. The symbol
"P1"appearsonthedisplay(bottom,left)foruserprofile1(seepict.1).
fit W Body Analyser Scale has a special function for
31