Tare Function; Auto-Hold Function; Switching Off The Scales; Resetting The Scales - ADE Ladina Instrucciones De Operación

Resetting the scales

TARE Function

This function is practical, for example, when baking, if you would like to add another
ingredient to the ingredients already on the scales.
1. Press TARE in order to set the scales back to "0".
2. Add the new substance. The weight of the added substance is shown on the display.
3. Repeat the process whenever you want to add more ingredients. The process can
be repeated as often as needed until the capacity limit (15 kg) is reached.

Auto-hold function

After activating the auto-hold function, the measured weight will still be shown after
removing the item/substance weighed.
1. Switch the scales on by briefly tapping on TARE.
2. Press and hold the MODE key until "H-ON" is shown on the display.
3. Place the item/substance to be weighed on the scales.
As soon as a beep tone sounds, the weighing process has concluded. You can remo-
ve the item/substance from the scales.
− The measured weight will then be displayed for approx. 30 seconds more.
− If you tap TARE, the indicator is immediately set to "0".
In order to switch the auto-hold function off again, press and hold MODE
until "H-OFF" is shown on the display.

Switching off the scales

− Hold down TARE until the indicator on the display goes out.
The scales automatically switch off if they are not used for approx.
60 seconds.
Resetting the scales
Reset the scales to factory settings if unusual or obviously incorrect values are shown
on the display.
1. Remove the batteries from the battery compartment and wait a moment.
2. Re-insert the batteries. Pay attention to the correct polarity of the batteries (+/-).
After switching the scales on, you can start weighing as usual.
18
Druckbuch LADINA.indb 18
Kitchen Scales KE 1601
05.02.2016 12:14:28