Start Of Application; Pc Interface Mode; Connection Details; Data Transmission - Lovibond IRiM Manual De Instrucciones

3 Start of Application

Infrared data from the instrument will be received by IRiM at 9600 baud. The baud rate can
be changed by the supplied software (see instruction manual "Data Acquisition Software").
When the unit is switched "ON" the last selected interface will be active.

3.1 PC interface mode

Press the "SELECT" key to scroll until the PC interface is set.
For data receiving on the PC a Data Acquisition Software is requiered. For installation and
operation see "Data Acquisition Software" manual.

3.1.1 Connection details

Connect the PC and the IRiM device port using a USB cable.

3.1.2 Data transmission

Keep the IRiM and the transmitting instrument (e.g. Photometer) in line of sight (face to
face). Start print command at the transmitting instrument. The data will be sent to the IRiM
and transmitted to the PC.

3.2 USB Printer interface mode

If necessary press the SELECT key to scroll until the USB interface mode is selected. If the USB
printer is not connected the interface status LED will flash. If data arrives while the device is
not ready, it will be lost.

3.2.1 Connection to USB printer

Connect the USB printer cable to USB host port on IRiM. If the printer is successfully connected
and ready to print the LED in front of the USB printer port will illuminate.
Note: The IRiM only works in combination with the printer HP Deskjet 6940!
3.2.2 Data transmission
Keep the IRiM and the transmitting instrument (e.g. Photometer) in line of sight (face to face).
Start print command at the transmitting instrument. The data will be sent to the IRiM and
will be printed on the USB printer.
Note: The IRiM does not support and will not indicate any printer related errors (Paper jam,
paper tray empty, etc.).
IRiM_2 04/2011
17