Installation - Urmet 1098-304 Guía Rápida De Inicio

Installation

Use a monitor with VGA or HDMI input for device start-up. Carefully follow the instructions below.
1 HDD housing's rear panel (with PoE)
6
5
1
USB port
2
HDMI output
3
VGA output
4
Network Connection Port
(to: router, switch, PoE switch)
Before installing the NVR, check that IP cameras are properly working and connected (via cable or WiFi) to the
same network as the NVR. For more details about camera configurations see the instructions provided with
cameras.
For NVR Installation follow these step:
• Connect the mouse to the USB port
• Connect the HDMI Output
• Connect the network cable to the port
Only for PoE Series: Connect one or more IP PoE Cameras with straight cable to one or more ports
• Switch on the device inserting the power connectors inside the plugs
position 1.
3
1 4
2
1
.
3
2
or VGA Output to the monitor used for the configuration of the IP cameras.
4
.
23
7
5
Plugs
6
Switches
7
PoE Ports (available on PoE NVR models) for direct
connection to IP camera (straight cable)
5
and position the switches
EN
7
6
on