Other Connections; Remote Control - LG AG-F Serie El Manual Del Propietario

Satellite dish connection
(Only satellite models)
Connect the TV to a satellite dish to a satellite socket with a satellite RF
cable (75 Ω).
HDMI ULTRA HD deep colour
settings
(Only UF67**)
• SETTINGS
PICTURE HDMI ULTRA HD Deep Colour
HDMI (1/2) ULTRA HD Deep Colour
- On : Support 4K @ 50/60 Hz (4:4:4, 4:2:2, 4:2:0)
- Off : Support 4K @ 50/60 Hz (4:2:0)
• All HDMI ports support the HDCP 2.2.
• 4K Source is only supported in HDMI input.
• 4K signal and content are not available in the RF/USB input.
• All HDMI input ports support 4K @ 50/60 Hz (For details on the
supported speciications, refer to the table below.) for high-
deinition video. Picture or sound may not be supported depending
on the speciications of the external device connected. In that case,
change the settings for HDMI ULTRA HD Deep Colour.
4K @ 50/60 Hz Support Format
Frame rate
Resolution
(Hz)
YCbCr 4:2:0
50.00
3840 x 2160p
59.94
4096 x 2160p
YCbCr 4:4:4
60.00
RGB 4:4:4
CI module connection
(Depending on model)
View the encrypted (pay) services in digital TV mode.
• Check if the CI module is inserted into the PCMCIA card slot in the
right direction. If the module is not inserted properly, this can
cause damage to the TV and the PCMCIA card slot.
• If the TV does not display any video and audio when CI+ CAM is
connected, please contact to the Terrestrial/Cable/Satellite Service
Operator.
Euro Scart connection
(Depending on model)
Transmits the video and audio signals from an external device to the
TV set. Connect the external device and the TV set with the euro scart
cable.
Current
input mode
Digital TV
Analogue TV, AV
Component
HDMI
1 TV Out : Outputs Analogue TV or Digital TV signals.
• Any Euro scart cable used must be signal shielded.
• When watching digital TV in 3D imaging mode, only 2D out signals

Other connections

Connect your TV to external devices. For the best picture and audio
Colour Depth /
quality, connect the external device and the TV with the HDMI cable.
Chroma Sampling
Some separate cable is not provided.
8 bit 10 bit 12 bit

Remote control

YCbCr 4:2:0
YCbCr 4:2:2
- -
(Depending on model)
- -
The descriptions in this manual are based on the buttons on the remote
control. Please read this manual carefully and use the TV correctly.
To replace batteries, open the battery cover, replace batteries (1.5
V AAA) matching the
compartment, and close the battery cover. To remove the batteries,
perform the installation actions in reverse.
• Do not mix old and new batteries, as this may damage the remote
• The remote control will not be included for all sales market.
Make sure to point the remote control toward the remote control sensor
on the TV.
Output
Type
can be output through the SCART cable. (Only 3D models)
and ends to the label inside the
CAUTION
control.
AV1
(TV Out 1 )
Digital TV
Analogue TV
13