Quarkpro FS-3000D Manual De Usuario página 5

To set the DMX address
1.- Select an address for the fixture on your controller. Look up the DIP switch setting for
the address in the table below
2.- Set pins 1 through 9 ON (1) or OFF (0) as listed in the table. Set pin 10 to OFF
Find the address in the table. Read the settings for pins 1-5 to the left and read the
settings for pins 6-9 above the address. "0" means OFF and "1" means ON.
Pin 10 is always OFF for DMX operation.
EN 4