Quarkpro FS-3000D Manual De Usuario página 7

SINGLE FLASH
To trigger single flashes, start with the intensity and flash rate at 0 and then set an
intensity on channel 1. When the value of channel 1 changes, the light will flash
once with the programmed intensity, duration, and effect.
STAND ALONE OPERATION
STAND ALONE FLASH RATE
To program stand alone execution
1.- Apply power to the fixture
2.- Set pin1 of the mode DIP switch to ON. Set pins 2 -5 to OFF. Set pin 6 to ON for low
power operation or to OFF for high power operation.
3.- Select either a flash rate or the blinder effect. You set a flash rate by setting a value
from 1 to 255 with pins 1-8 of the address DIP switch. The value required to achieve a
desired flash rate can be calculated as follows.
2 x AC frequency
DIP value = 261 -
Flash rate
To achieve a flash rate of 10 flashes per second on a 50 Hz AC power supply, for example,
the DIP value is 251. To select the blinder effect instead, set pin 9 to ON.
4. Set DIP switch pin 10 to OFF for normally off operation, or to ON for normally on
operation.
EN 6