Publicidad
Idiomas disponibles
Idiomas disponibles
4. FITTING THE FOCUS BAR
SPINDLE.-
Insert the focus bar spindle (23)
through the horizontal support on the
main post, Fig.4, leaving it centred
between the two lines (B) marked on
the spindle. Tighten screws (67)
securely.
5. FITTING THE FEET.-
Take the right foot (7R) and fit the
bush for the focus bar (17) onto the
spindle (23) Fig.5.
Next, insert the connecting rod (R)
onto the square shaft (30), Fig.5, and
use
screw
(27)
connecting rod securely.
Take screw (13), along with washer
(14) and tighten it securely onto the
spindle (23), Fig.5.
ATTENTION: Take the left foot (7L)
and perform the same assembly
procedure as with the right foot (7R),
making sure that the left connecting
rod (L) is at 180 degrees with respect
to the right connecting rod, as shown
in Fig.5A.
Fit the bottle holder (34) onto the
handlebar post support on the main
body (1) using screws (66), Fig.5A.
WARNING:
It is important to retighten all of the
screws involved in assembling the
machine after a few hours of use,
paying special attention to screws (27)
for the connecting rods (R) and (L),
Fig.5A.
6. FITTING THE FOOTRESTS.-
Position the left footrest (35 marked
with the letter "L") on top of the unit's
left foot (7L), Fig.5, (left and right
to
tighten
the
refers to the user's position doing
exercise) refit the screws (43), and
tighten securely.
Next, position the right footrest (36
marked with the letter "R") on top of
the right foot (7R), refit the screws
(43), and tighten securely.
7. FITTING THE UPPER
FOCUS BARS.-
Take the top left focus bar (6) (marked
with the letter L).
Insert the bar into the bottom left focus
bar (5L), lining up the letters (L), Fig.6,
tighten screw (T) on the bottom focus
bar (5L) with the 8 mm Allen key. Now
go through the same procedure for the
top right focus bar (26).
8. EXERTION SETTINGS.-
To provide an even level of exertion
during exercise, this appliance is
equipped with a tensioning control
(19), Fig.7.
To increase pedal resistance turn the
tensioning control (19) clockwise (+)
until the exertion level best suits your
exercise requirements. To reduce
pedal resistance turn the tensioning
control (19) anticlockwise (-).
9. HANDLEBAR STEM
HEIGHT ADJUSTMENT.-
1) Loosen lever (79), located on the
vertical tube on the main body (1),
Fig.8, by turning it anticlockwise.
2) Slide the handlebar stem (2) up or
down to the required height and then
retighten the lever (79) by turning it
clockwise, Fig.8.
15
Publicidad
