hager S761-22 Manual De Instrucciones página 99

Configuration
• Use the programming key to programme the following sequence:
LED
once and hold
press key
(10 s approx.)
configuration
sequence
1) To start
the sequence,
press and hold
the key until
the LED goes out
If you make a programming error, the programming LED will flash quickly.You must carry out the programming sequence again
from the start.
once
and hold
........ times*
(5 s approx.)
2) Press the key 3) Press
as many times and hold
as the parameter the key until
number the LED
goes out
........ times*
4) Press the key
as many times as
the parameter value
99
once and hold
* Make a note
(10 s approx.)
of the chosen
parameter
number/value
5) To end LED permanently
the sequence, ON for 2 sec.
press and hold
the key until configuration correct
the LED goes out
=
G
B