Installing The Appliance; Installation; Connecting The Air Exhaust Tube - NEW POL eXperience XS 251 CO Manual De Instrucciones

GB
Installation must be carried out by qualified personnel in line with the instructions supplied by the manu-
facturer. Incorrect installation may result in damage and injury.
IInstall the drier near to a win-
dow to facilitate the evacuation
of the damp air from the drier.
The exhaust tube must be
used to prevent condensation,
and must be inserted in hole
A at the bottom of the back
panel of the appliance (fig. 3).
Never cover the air intake at
the back of the appliance.
Adjustable feet. Place the drier
upright so that it rests firmly on
all four feet. Level the drier by
adjusting the feet as follows:
Lift the drier slightly.
Adjust the feet to the correct
height (fig. 5).
(Do not unscrew the feet to
Connect the exhaust tube to the
outlet on the back of the drier
(fig.6), as follows:
Connect one end of the tube to
the connector piece supplied.
Rotate the connecting piece (to-
gether with the tube) anticlock-
wise in the drier outlet hole.
Carry the tube away from the
back of the drier to the left or
6
14

INSTALLING THE APPLIANCE

INSTALLATION

Place the filter in its normal
position as shown (fig. 4).
3
LEVELLING THE DRIER
much and do not use a screw-
driver).
n Lower the drier.
A badly levelled machine may
cause damage to the bearings
and lead to their premature wear.
This drier does not need to be
anchored to the floor.

CONNECTING THE AIR EXHAUST TUBE

right by means of the recess
at the bottom of the drier body.
Position the other end of the tube
near to a window or a ventilation
outlet on an external wall. If this
is not possible, ensure that the
room is well ventilated when the
drier is being used. Use the sup-
port supplied to anchor the tube
(fig. 7).
7
Clean the inside of the drying
drum using a damp cloth to
remove any dust deposits.
A
4
5
Important: The air exhaust
tube must be connected
even if the air is not dis-
charged outdoors, other-
wise the drier will re-absorb
the discharged damp air and
thus prolong the drying
time. Damp air can also
damage the drier. Although
the air discharged from the
exhaust tube is only warm
and damp and does not con-
stitute a danger, it must
never be directed towards
people, animals or plants.
Important: The exhausted air
must not be conveyed to a
chimney discharging fumes
generated by gas or other
fuel burning appliances.
SM1775