Electrical Connection; Using The Appliance; Description Of The Functions - NEW POL eXperience XS 251 CO Manual De Instrucciones

Make sure that the voltage in-
dicated on the identification
plate attached to the back of
the appliance corresponds to
that of the mains supply.
All cutouts, electric wiring and
mains sockets must have a
rating such that enables them
to support the maximum load
indicated on the identification
plate.
The mains supply to which the
appliance is connected must
be fitted with an earthing sys-
tem. If this is not the case, the
manufacturer will not be held
liable for any incidents that
9
0
1
10
0
1
11
SM1775
INSTALLING THE APPLIANCE

ELECTRICAL CONNECTION

8
may occur (fig. 8).
If the power supply cable is
damaged in any way, contact
the appropriate specialised
customer technical service
centre.
The drier must not be con-

USING THE APPLIANCE

DESCRIPTION OF THE FUNCTIONS

Drying time control knob: Rotate the knob to select the required
drying times (fig._9). Refer to the program table to select the pro-
gram according to the type of fabric.
At the end of each drying cycle, the appliance effects a 10 – 15
minute cooling cycle, during which time the appliance is still
switched on.
N.B. The timer knob must always be rotated clockwise (fig. 9).
ON/OFF button: Press this button to start the drying cycle (the
indicator will light up) (fig. 10).
Delicate or energetic drying button: This button is used to se-
lect the type of drying cycle to run: Energetic or delicate (fig.11).
nected to the mains supply
using indirect methods such
as extension leads or multiple
adapters.
Position the appliance so that
the power supply cable is eas-
ily accessible for disconnec-
tion when the need arises.
Important: On completion of
the drying cycle, disconnect
the appliance from the mains
supply to prevent young chil-
dren from operating the
drier.
GB
15